In short:
- Panic and push-bar hardware lets anyone open an exit door from inside with one push, without a key, while the outside can stay locked.
- Never chain, padlock or wedge an exit door shut while people are in the building. Hardware makers say exit devices must not be locked or blocked while the building is occupied.
- The National Building Regulations require buildings to provide for the safe evacuation of occupants. For what applies to your premises, ask the City's fire safety officers or your building professional.
- We supply, fit and repair exit hardware. We don't certify compliance.
What a panic bar actually does
A panic bar (also called a push bar, crash bar or touch bar) is a horizontal bar across the inside of a door. Pushing anywhere along it withdraws the latch or bolts and the door swings open in the direction of escape. No key, no handle to find, no button to work out. That matters most when a room fills with smoke or a crowd moves towards the door at once.
From outside, the same door can stay locked. Many devices have no outside handle at all; others take an outside access device, a lever or knob with a key cylinder, so staff can come in through that door when they need to. The principle is simple: secure from the outside, always free from the inside while the building is in use.
Panic hardware or emergency exit hardware?
Hardware makers use European product standards to tell two families of device apart. ASSA ABLOY's guide summarises the difference like this:
| Panic exit device (EN 1125) | Emergency exit device (EN 179) | |
|---|---|---|
| Operated by | A horizontal bar across most of the door width | A lever handle or push pad |
| Meant for | Public areas where people may not know the building | Areas where the users know the layout, such as staff-only zones |
| Door swing | Outward-opening doors only | Can suit some inward-opening doors |
| If unsure | The maker's advice is to specify panic hardware | — |
The same guide warns that an outside access device or replacement part should be one tested with the inside hardware, because mixing parts can undo the device's rating. When we quote, we match parts to the device you have, or replace the set.
What the rules say, in plain terms
The National Building Regulations (Part T, fire protection) require every building to be designed, built and equipped so that, in a fire, the occupants are protected and provision is made for their safe evacuation. Compliance with SANS 10400-T is deemed to satisfy that requirement. Exactly what your building needs, from the number of exits to the type of hardware on each, depends on its use, size and layout, and those details sit in the standard and in your approved plans.
We can't tell you whether your premises comply, and we don't issue compliance certificates. For what applies to your building, ask the City's Fire and Rescue Services fire safety officers, your architect or your fire consultant. We'll fit and repair the hardware they specify.
Keeping the exit usable and the shop secure
Exit doors are often at the back of a shop or office, beside a loading area or a lane, which is exactly where owners worry about break-ins after hours. The answer is to secure the door in ways that don't trap anyone inside during trading hours:
- Use the hardware as designed. A good vertical-rod panic bar bolts the door top and bottom, which is strong in itself.
- Lock up properly at closing time, and unlock before anyone arrives. If you add any after-hours lock, make it part of the opening routine to undo it before staff or customers are inside.
- Protect the outside. A solid door and frame, a guard over the latch edge where suitable, and good lighting outside all help without touching the inside release.
- Keep the route clear. Stock, bins and deliveries stacked in front of an exit make even good hardware useless.
Never chain, padlock or wedge an exit door while people are in the building. ASSA ABLOY's guide says panic and emergency exit devices should not be locked or blocked whilst the building is occupied, and that escape doors must open easily and immediately from the inside.
Signs your panic bar needs attention
- The bar needs a hard shove, or only works if you push near one end.
- The door doesn't latch on its own after closing, so it's left "on the latch" or propped.
- The top or bottom bolt drags on the frame or floor, or its floor socket is full of grit.
- The bar rattles, a cover is missing, or a rod is bent.
- The outside access device key turns but doesn't withdraw the latch.
- The door closer slams the door or doesn't close it fully, putting strain on the bolts.
A quick weekly routine helps: open each exit from inside with a single push, let it close on its own, and check it latched. Keep the floor socket swept. Don't oil the device with a general-purpose spray; follow the maker's instructions, because the wrong product attracts grit.
Repair or replace?
| Repair is usually sensible when… | Replacement is usually sensible when… |
|---|---|
| Bolts or keeps are out of line because the door has dropped | The mechanism is cracked or worn out inside |
| A rod is bent but the device body is sound | Parts for that device are no longer available |
| The outside access cylinder is worn | The door's use has changed and it needs a different type of device |
| The closer needs adjusting so the door latches | Someone forced the door and the device is distorted |
Exit hardware is part of our commercial locksmith service. Worn parts fall under lock repairs, and full device swaps under lock replacement. If the door was forced, see break-in repairs. Schools and crèches have their own mix of exits and gates; read locks for crèches, aftercare and small schools.
Somerset West shops, offices and workshops
Exit doors turn up across the town's business areas: shops, banks and professional rooms in the town centre, retail and offices on the Somerset Mall side of town, and workshops and industrial units in Firgrove. Inside a managed centre, check with centre management before changing hardware on a shared exit. In a business park, let the gatehouse know a locksmith is on the way.
When you contact us, it helps to send:
- Photos of the door from inside and outside, and a close-up of the bar and any label on it.
- Whether it's a single or double door, and which way it opens.
- What's wrong: stiff, not latching, outside key not working, damaged.
- When the building is quiet, if you'd like the work done outside trading hours.
We're open 24/7. The R350 call-out fee. The technician assesses the job on site and gives you the price before any work starts. Nothing is done until you agree. Payment is by EFT, cash or card. For everything else we do, visit our mobile locksmith in Somerset West homepage.
Questions
Can I put a padlock on the panic bar at night?
Only if the building is empty and the padlock is removed before anyone comes in, and even then it's easy to forget. A sounder approach is a properly fitted device that bolts top and bottom, plus a strong door and frame. Ask the City's fire safety officers if you're unsure what's acceptable for your premises.
Can a panic bar be fitted to an inward-opening door?
Hardware makers say panic devices to EN 1125 are for outward-opening doors. Some emergency exit devices can suit inward-opening doors in staff areas. Whether that's acceptable for your exit is a question for your building professional or the fire safety officers.
Will you give us a certificate after fitting?
No. We supply, fit and repair the hardware and explain what we've done, but we don't certify compliance. That comes from the relevant authority or your building professional.
Need a locksmith to look at it?
If this hasn't solved the problem, our commercial locksmith service covers it. We're a mobile locksmith in Somerset West, so we come to your door. Areas where this comes up often include Somerset West Central, Paardevlei, Firgrove.
Sources and further reading
- Acts Online: National Building Regulations, regulation T1 (general requirement) — Buildings must protect occupants and provide for their safe evacuation in a fire; compliance with SANS 10400-T is deemed to satisfy the requirement.
- ASSA ABLOY: Panic and emergency escape hardware — EN 1125 panic devices versus EN 179 emergency devices; panic devices not for inward-opening doors; devices must not be locked or blocked while the building is occupied; outside access devices must be tested with the inside hardware.
- Wikipedia: Somerset West — Somerset Mall, beside the N2, is the largest shopping centre in the Helderberg.
- Property24: Firgrove property for sale — Most Firgrove listings are industrial or commercial units.